AABCOOLING Compressed Gas Duster FLEX 750ml

Compressed air for cleaning – AABCOOLING Compressed Gas Duster FLEX 750 ml

AABCOOLING Compressed Gas Duster FLEX 750 ml is a mixture of gases under high pressure. Its powerful jet removes dust, dirt, liquids and other loosely adhering contaminants – even from hard-to-reach places. Eco-friendly and fully biodegradable – freon-free and odourless. Ideal for home, workshop and professional service use.

Two nozzles and a 60 cm flexible tube

The short 2 cm nozzle lets you clean precisely at close range while holding the item in your hand. For general cleaning, use the tube with the 15 cm nozzle – it is thin, long and flexible, so it easily reaches the smallest nooks and crannies.

The 60 cm FLEX flexible tube is the answer to cleaning very hard-to-reach places. Hold the hose in your hand, guide its tip to the spot and press the nozzle in short bursts. You can cut the tube to the length you need.

How to fit the 60 cm tube? Pull the 15 cm or 2 cm tube out of the nozzle, then push the FLEX tube into the nozzle opening.

Cleaning computers, laptops and office equipment

Need to clean delicate computer or laptop components or a dusty keyboard? The jet of compressed gas blows dust out of places a cloth cannot reach. High pressure ensures effective cleaning.

The product removes dust and loose contaminants from computer equipment, consumer electronics, household appliances and office devices. Use it to clean printers, copiers and fax machines, or to remove toner spilled inside a printer.

Smartphones, cameras and precision devices

A dirty phone speaker or dust in the charging port can disrupt how your device works. AABCOOLING Compressed Gas Duster FLEX also helps you clean a camera sensor and blow dust, dirt or water droplets out of hair dryers, sewing machines, watches, photographic equipment, cash registers and other precision mechanical devices.

For the workshop and DIY

Dusty workshop tools, furniture panels or hinges? Point the applicator tube at the part, press the nozzle and blow away the dust.

How to use compressed air

1. Disconnect the device you are cleaning from the power supply.
2. Wait 30 s for the voltage on the electronic components to discharge (hold down the Power button).
3. Attach the chosen nozzle with its tube or the 60 cm flexible tube. Do not shake the can right before use.
4. Hold the can upright with the nozzle facing up – do not tilt it more than 60° while cleaning.
5. Point the tube at the part from a distance of about 10 cm and press the nozzle in short bursts. Done!

The can also works as a freeze spray: held upside down (nozzle facing down), it cools down to -50°C.

One product – many uses

Its wide range of uses means you do not have to buy several different products. AABCOOLING specialises in PC cooling and cleaning chemicals, and Compressed Gas Duster is one of our most frequently chosen products, highly rated by customers in Poland and abroad.

Important safety information

• Read the product label and the safety data sheet before use.
• The product contains a mixture of flammable gases (propane, butane, isobutane) – use it with care.
• Ensure good ventilation of the room during use.
• The devices being cleaned must always be disconnected from the power supply.
• Avoid contact with skin – risk of frostbite.
• Wear protective gloves and safety glasses.
• Extremely flammable. Keep away from open flames and embers.
• Do not expose to direct sunlight.
• Do not store at temperatures above 50°C.